Community Live-All you need to know about ISR Fixed Branch Platforms
This event took place on Tuesday 17th, August 2021 at 10:00 hrs PDT
Learn about Cisco’s ISR Fixed Platforms and how it fits into Cisco’s overall Branch offerings. This session covered ISR800, ISR900 and ISR1000 Branch platforms family and look at the architecture and key capabilities of each of these platforms. We also covered different use cases these platforms address as part of this session and look at some of the key positioning aspects of these platforms. This session also covered different management options available and lastly, we looked at migration of ISR800 and ISR900 to ISR1000 platforms.
Platform Deep Dives (Architecture, Features, Modules, Use cases)– ISR 1000, ISR1100X-4G/6G, ISR 900 and ISR800
Performance and Test Methodologies
Migration options from ISR800/900 to ISR1K
Abhishek is a technical marketing engineer and has been with Cisco since 2019, after graduating from Northeastern University with a Master’s degree in Telecommunication Systems. At Cisco he is currently part of the routing BU primarily working on the ISR1K product portfolio as well as LTE and WiFi technologies.
Prakash is a Technical Marketing Engineer and has been with Cisco for about 1 year. His overall experience working on Cisco products is over 13+ years involved with different technologies in Routing and Switching world. He is currently leading WAN Optimization, vEdge, ISR1100 and ISR1100X series products from Technical Marketing side.
As TMEs they are responsible for collaborating with different stakeholders on product development, monitoring product performance and training marketing teams on product specifications and functionalities.
Do you know you can get answers before opening a TAC case by visiting the Cisco Community? For more information, visit the Networking page.
Hello everyone I am fairly new to advanced networking concepts. I do some networking for my company but most of it is not setting up new devices or networks. Anyways, I was able to get my hands on a Cisco ISR 2921 and a Cisco 3560-x PoE L3 switch fro...
Hi guys, I have a Cisco switch configured with two vlans : VLAN 10 : VoiceVLAN 20 : DATA My switch ports are configured as shown below : interface GigabitEthernet1/0/Xswitchport mode accessswitchport access vlan 20switchport voic...
On ASA IPv4 "dual ISP" failover is well documented (ex: here and here) and works well. Is this a supported feature for IPv6?Also, are there any technical documents that describe best practices for configuring IPv6 with two ISPs on a Cisco ASA?Th...
I am trying to pull a report from Cisco Prime that shows the switch stack Chassis ID. I also found that the Chassis ID matches the interface labeled GigabitEthernet0/0 but I cannot find a report that show that either. Any help on getting this ...
Hello, We recently have had issues of where IP tracking was causing some Windows PCs and IOT devices to detect (falsely) that another device was using the same IP, and so in the case of Windows the user would see a duplicate IP message, and in the ca...