Community Live-Application Hosting on ISR, ASR, CSR and Catalyst Routing Platforms
This event had place on Tuesday 20th, July 2021 at 10:00 hrs PDT
Edge Compute is evolving as a key pillar as part of next-generation Enterprise WAN Edge deployments. This session will focus on Containerized Application Hosting capabilities of Enterprise Routing platforms. At the start, it shall establish the understanding of Platform Service Plane architecture and how that accommodates the Edge Compute possibilities in the form of IOx App-hosting Infrastructure. The intermediate level session will also touch into the ‘how’ part of the installation, maintenance, troubleshooting for an end-to-end workflow. More importantly, it will highlight the deployment best practices of native LXC, KVM applications in the WAN Edge Routing Platforms.
Routing Platforms Service Plane
Application Hosting Architecture
Edge Compute Solutions
Sumant Mali is a passionate Network Enthusiast with 12+ years of Industry Experience. Currently a Technical Marketing Engineer for ASR 1K as well as Catalyst 8500 series. A hardcore Quality Assurance engineer with Thrilling Escalation Handling Experience that has shaped him into who he is today.
Do you know you can get answers before opening a TAC case by visiting the Cisco Community? For more information, visit the Networking page.
I have two primary windows domain controllers with separate ip addresses. I would like one to act as a primary DNS and the other secondary. How do i get my cisco router to dynamically assign the the two windows DNS server ip addresses to all clients withi...
Good day,I have a windows domain controller that has the DHCP role installed. The DHCP role issues out IP addresses,. I would now like like the cisco router to issue out IP addresses to clients within my domain. What is the process of setting this up ?Rou...
Hey, I need a bit of help. I need to set up a remote access port forward to a machine existing in a vrf. Because it's in a vrf I cannot use the interface command, I can only specify the wan IP. I have no option for a static IP so i ne...
Hello Team, We are configuring dot1x on ASR1001-x, the configuration is detailed below: Router(config)# dot1x system-auth-control
Router(config)# aaa new-model
Router(config)# aaa authentication dot1x default group radius
Currently have a nm-4g, 4 port sfp card installed in my C9300-24P, using g1/1 as my trunk uplink. I have the need for my fiber trunks leaving the switch than the nm-4g card can accommodate and have purchased the nm-8x, 8 port SFP card. This is...