Community Live- Introduction to Smart Licensing on Catalyst Switches
(Live event - formerly known as Webcast- Thursday 30 July, 2020 at 10 am Pacific/ 1 pm Eastern / 7 pm Paris)
This event had place on Thursday 30th, July 2020 at 10hrs PDT
This event provides an introduction to smart licensing on Cisco Catalyst switches, including 9000 (9200, 9300, 9400, 9500, 9500H, and 9600 Series) and 3000 (3650 and 3850 Series) switches. Cisco experts review the benefits, basic concepts, considerations, different types of registrations, and general FAQs. In addition, a live demonstration on how to register a license with a Cisco server is provided.
Introduction – What is smart licensing?
Types of registration
Essential configurations on the switch
Differences between 9000 and 3000 switches
Demonstration of the registration process
Common issues and a workaround
Luis Celis is a Technical Consulting Engineer on the Enterprise Routing & Switching team at Cisco’s Technical Assistance Center in Mexico. He provides top-level technical support for global customers with Catalyst 9000 and 6800 switches. Previously, he collaborated with the Service Provider team. Before joining Cisco, he worked with Ericsson solving customers challenges and providing solutions for massive network optimizations. Luis holds a bachelor’s degree in Communications and Electronics Engineering from the Instituto Politecnico Nacional (IPN) in Mexico.
For more information, visit the Switching category.
This event is open to everyone, including students, instructors, Cisco customers and partners.
Do you know you can get answers before opening a TAC case by visiting the Cisco Community.
Hello everyone I am fairly new to advanced networking concepts. I do some networking for my company but most of it is not setting up new devices or networks. Anyways, I was able to get my hands on a Cisco ISR 2921 and a Cisco 3560-x PoE L3 switch fro...
Hi guys, I have a Cisco switch configured with two vlans : VLAN 10 : VoiceVLAN 20 : DATA My switch ports are configured as shown below : interface GigabitEthernet1/0/Xswitchport mode accessswitchport access vlan 20switchport voic...
On ASA IPv4 "dual ISP" failover is well documented (ex: here and here) and works well. Is this a supported feature for IPv6?Also, are there any technical documents that describe best practices for configuring IPv6 with two ISPs on a Cisco ASA?Th...
I am trying to pull a report from Cisco Prime that shows the switch stack Chassis ID. I also found that the Chassis ID matches the interface labeled GigabitEthernet0/0 but I cannot find a report that show that either. Any help on getting this ...
Hello, We recently have had issues of where IP tracking was causing some Windows PCs and IOT devices to detect (falsely) that another device was using the same IP, and so in the case of Windows the user would see a duplicate IP message, and in the ca...