08-31-2019 01:03 AM - edited 08-31-2019 01:12 AM
The configurations restore is not working for me.
SPA112.2 FXS Firmware 1.4.1 Hardware 1.1.0
I get:
Restore has failed.
SPA112 is restarting...You will be returned to the Login page in a few minutes.
Only two steps, Click backup (which works) then try and restore it.
Is there some trick to making this work? I have tried on Firefox and Chrome?
08-31-2019 02:24 AM
Well known and discussed already.
08-31-2019 08:30 PM
@Dan Lukes wrote:Well known and discussed already.
It is may be an unaddressed well known fault, however:
I am but a simple user who followed the recipe of my VOIP provider and Cisco's website which states:
"IMPORTANT
As with any firmware release, read these release notes before you upgrade the firmware. We also recommend that you back up the configuration before you perform any firmware upgrade."
That should state: "Backup your configurations using 'http://admin:password@<ip addr>/admin/config.xml'
and also make an additional record of your configured passwords"
The takeaway lesson, for me, is that one should read all of the outstanding bug reports prior to purchasing a product.
09-01-2019 12:12 AM
That should state:
There are no simple "catch all" recipes in IT. I remember releases exporting broken config.xml.
There's more complex lesson:
one should read all of the outstanding bug reports prior to purchasing a product.
Good, but this helps only to a limited extent. Vendor often don't publish most critical bugs. Cisco have no public list of outstanding bug reports at all. Just few bugs are mentioned in "Open caveats" section of Release Notes, but that's all.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide