cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
503
Views
3
Helpful
5
Replies
Beginner

APIC-EM discovery using AD/RADIUS credentials

I installed APIC-EM and was trying to run device discovery.  We use Active Directory RADIUS for auth so for user name I have to enter: domain\user. APIC-EM interface complains that I am using an illegal char \.  I have tried it using '\' and "\", also tried using user@domain still get an error.  Any thoughts?

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Cisco Employee

Re: APIC-EM discovery using AD/RADIUS credentials

Ok, it's a bug. Wii get it fixed.

Thanks for finding this.

View solution in original post

5 REPLIES 5
Highlighted
Cisco Employee

Re: APIC-EM discovery using AD/RADIUS credentials

Please please describe where you saw the error and exactly error message ?

Is the following step you were trying to do ?

Highlighted
Beginner

Re: APIC-EM discovery using AD/RADIUS credentials

I think the screen you are showing is in Discovery and then CLI credentials.  I was trying to add a global CLI Credentials under Settings (top right corner) -> CLI Credentials.Screen Shot 2016-04-26 at 11.22.52.png

Highlighted
Cisco Employee

Re: APIC-EM discovery using AD/RADIUS credentials

Thanks, I see the same. I will get some help.

Highlighted
Cisco Employee

Re: APIC-EM discovery using AD/RADIUS credentials

Ok, it's a bug. Wii get it fixed.

Thanks for finding this.

View solution in original post

Highlighted
Beginner

Re: APIC-EM discovery using AD/RADIUS credentials

You must be with Cisco.  Thanks for taking care of this.