Cisco Bug Discussions

I see there's been no activity on this since February.  This is a blocker and we've had to prevent roll out of this firmware due to this bug.  I've read the cause of this bug - the expansion module is now magically meant to carry the wallpaper over f...

Hi,we have single power supply and the given error log generate again and again Feb 22 07:42:40.741: %ENVIRONMENTAL-1-ALERT: V: PEM Out, Location: P0, State: Warning, Reading: 13500 mV please response what is this why our router restart for again and...

Is this bug really fixed in 6.1.4 because I'm seeing something very similar in this version.  The fix is to remove the RT being imported from the VRF, and then re adding it.  This was also the fix in this bug originally.  So the symptoms are very sim...

I have hit this bug on one of my Catalyst 2960X Stacks running 15.2(7)E0a --sk

Hello Everyone,    We are facing below error While migrating CUCM 9.1 to 11.5 using PCD,   "No Network Connection to the Node.This is due to the IP of the node did not come up after 1 hr install. Could be a Network delay issue"   I understand that th...

Does anyone else feel that it's a problem when an Outbreak occurs on the ESA that no notifications are sent out to the administrator of the ESA? We rely on notifications from the ESA to let us know when a security event occurs and cannot spend our da...

Hi mates, I am using Cisco Devnet lab to switch versions for Experimental Version 15.2. I have tried to implement Fallback Bridging for VLANs but doesn't work anymore. it thorough error for below.  IOS2-1-DLS1(config)#bridge 1  protocol vlan-bridge  ...

I can confirm, this also happens on "Cisco IOS XE Software, Version 16.06.04" running on a WS-C3850-12S-E

Dear Cisco, why is the assigned CVE-2019-1559 not listed within the Security Advisories or published over the RSS-Feed? RegardsMarco

Agree with marco.kitz.Why Cisco do not published anymore advisories related to third-party libraries  ; such as OpenSSL ?

I encountered same issue but i found out that there was some configuration pending deployment, I was able to resolve it by deploying the pending configuration on FDM. Thanks. 

Every single upgrade cycle since X8.10 we have to factory reset our entire cluster of Expressway Cores and Edges in order to get them running properly again. Is everyone running into this issue? What is Cisco doing to mitigate this problem? It's been...

I ran into this bug due to a failed node addition/cluster expansion.  I was adding a brand new converged node, and it failed on the second to last step of the workflow.  The node was partially added in: it showed in HX Connect and vCenter, but storag...

We really really REALLY want this too.  We have a service model where our staff are asked to do work at different locations frequently but we can't do extension mobility for everyone (nor does it make sense when simply working from the office next do...

Hi, Am facing issue with Call variable Layout. For few of the agents, Call variable layout is pop up is delayed. Some times call variable layout pop up is disappeared even before the call gets disconnected.  Finesse Version: 11.5.1 with ES02 Regards,...