Cisco Bug Discussions

hello.   Many Log occurs by this system.  "mm dd hh:mm:ss xxx xxx: *apfOrphanSocketTask: mm dd hh:mm:ss.247: %APF-4-REGISTER_IPADD_ON_MSCB_FAILED: apf_foreignap.c:1767 Could not Register IP Add on MSCB. MSCB still in init state. mobility state, apfMs...

Hello,   why was the case updated ? I thought it was already fixed in PI 3.1.7 Maintenance Release.   Best Regards  

We also receive this warning every 62 minutes after we upgrade to 11.0.0-267. Workaround or Solution?

Hi,   I am also observing the same problem. Can anyone help, how can we create more than 2 interfaces?

Hi,   Is it possible to have a date, even approximate, for the release of this hotfix?   Regards

In Cisco Security Advisory, it is stated N5K  running on software version 7.1 is affected.  However, in its documentation for Bug CSCuq71257, it mentioned only 7.1(0)RGD(0.5) is affected.   My question, if my N5K is running on 7.1(4), is it also affe...

I'm hoping to find out if there is any way to increase the timeout from 5 seconds, in order to alleviate this message.  Refreshing the screen fixes the problem, but I'd like to prevent this from happening at all if possible.   

How can manually flush URL filtering cache ?! as I have requested category change on brightcloud and it has been changed a few days ago. also I have triggered URL filtering update  but FirePower still work on old URL category

The 2# link is not valid. Update the link below: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/2-x/L2_config/b_Cisco_APIC_Layer_2_Configuration_Guide/b_Cisco_APIC_Layer_2_Configuration_Guide_chapter_0100.html#d2789e2075a1635 (...

Anyone else see this bug in 11.5.1.11001-34 since the Jakarta Patch?   - NOC

The RoomReady controller connects to the codec via SSH and polls the codec 1 time every 60 seconds. What is the suggested polling time? The RoomReady controller is connected to 500+ codecs around the world and the only time this issue is seen is when...

Where is the statistics for the DSL line connection at this model?   I can't find it in the GUI or the CLI

This problem has still not been fixed. The issues persist over multiple controllers (5508 & 5520) with different AP Models (2600,2700.2800). Only solution as of now is to MARK "bittorrent" traffic on the WLC - AVC - Profile section.   Is there any ot...

WARNING: No backup device is configured. This is required to recover your system in case of failure. What is the solution to fix this issue.

Hi,   Is that all 2.1 ISE is affected for all build number? We are currently use 2.1.0474 with patch 3, customer concern that this version is affected review vulnerability.