Cisco Router 1841 struck at ssh 1.99 has been enabled. not going to config mode, not rommon mode.

[ravi313]

Hi.. 

i am Network Engineer i am trying to configure cisco 1841 router, after connecting through console cable iso image self decompress completes. Then show % SSH-5-ENABLED: SSH 1.99 HAS BEEN ENABLED. router struck hear.

Not breaking to rommon mode also. Not going to config mode.

[Daniele Giordano]

Can you block the boot using ctrl-break?

Can you enter in rommon mode and load the default config?

Regards.

[ravi313]

No i cannot block boot cntrl-break, after pressing cntrl-break it is
not going to

rommon mode.

[fbabashahi]

Hi
if there is not any chance to enter do reset factory, and again config it.
for factory reset i think you should keep power key down for a few seconds (5-10)