Cat 9300 showing error after upgradations- .Package is missing

[Mayur Salunkhe]

Recently i have competed IOS upgradation of cat 9300 switch after upgradation i got error like package is missing.

when i checked more package.conf file all files are present in file nothing is missing still getting error.

Also when i checked sh boot sys under boot sequence old file .bin also there and new package.conf also there.

[Leo Laohoo]

Post the complete output to the following commands: 

dir
more bootflash:packages.conf | begin rp_boot

[Mayur Salunkhe]

Please find attached output

[Leo Laohoo]

---

@Mayur Salunkhe wrote:
Please find attached output

---

Where?

[Mayur Salunkhe]

Attached, 

[Leo Laohoo]

F.ck. I think DNAC erased everything.  

This can be fixed easily.  

1.  Copy the firmware back into the switch.  
2.  Do the following: 

conf t
 software auto-upgrade enable
end
wr

3.  Unpack the package: 

request platform software package install switch all file flash:filename.bin on-reboot new auto-copy verbose

4.  Confirm that the switch will boot the correct firmware: 

more bootflash:packages.conf | begin rp_boot

5.  Save the config. 

6.  Reboot

[Mayur Salunkhe]

is there any another way without reboot when i checked files under package.conf all files are there shall i uploade .bin file and extract it into packages bcz under dir latest version bin file is delated.

[Leo Laohoo]

Follow Steps 1 to Step 4 and it will put the package files back without a reboot.  

This is a stack of 9300 -- Lady Luck shines down on you.  Look at Step 3.  Do you see the option "on-reboot"?  (That's a bug:  CSCve94966.  It is suppose to say "NO-reboot".)   If the option "on-reboot" is used, the process will extract all the packages from the BIN file and STOP.  No reboot.

[Leo Laohoo]

Please share with us the DNAC version or build number for references.

[Mayur Salunkhe]

Hi Leo,

We are not using DNAC to upgrade device we have inhouse automation tool.

[Mayur Salunkhe]

Hi Leo,

Thanks for help, i restored files in switch but still showing error under sh logg.

Please find attached snap

[Leo Laohoo]

conf t
 service internal
end
clear install state
conf t
 no service internal
end
wr

[Leo Laohoo]

@Mayur Salunkhe 

What is the DNAC version? 

(This information is very important because some DNAC people are watching this thread.)

[Mayur Salunkhe]

Hi Leo, 

We are not using DNAC to upgrade device its inhouse automation tool.

Thanks