10-10-2018 12:27 AM - edited 03-08-2019 05:27 PM
Hi all,
I have some questions about how to configure a cat 9K for DNAC assurance.
Solved! Go to Solution.
04-13-2019 11:31 AM
Hi Diana,
Just to correct you .
During device discovery Dnac configures below :
1) PKI
2)IPDT
3)HTTP server & SSH source
4) SNMP RO & RW community
When Telemetry configured for switch then below gets configured :
1) Syslog
2) SNMP traps
You need to configure the telemetry profile for optimal visibility .By default telemetry is disabled .
Cheers,
Dheeraj
10-11-2018 01:37 AM
1) DNA-C acts as a "kind of" CA and once you add your 9.4k to DNA it recives a certificate from DNAC for trustworthy naughty things ;)
10-24-2018 02:26 PM
Hello!
When you apply the telemetry profile to your switch you should get the next configuration:
device-tracking tracking
!
device-tracking policy IPDT_MAX_10
limit address-count 10
no protocol udp
tracking enable
!
!
And this command will be applied in all your access ports:
device-tracking attach-policy IPDT_MAX_10
This way the DNA will collect all the client telemetry information and can use it for health diagnostic and for troubleshooting purposes.
Please do not forget to rate useful post.
Best Regards,
04-13-2019 11:31 AM
Hi Diana,
Just to correct you .
During device discovery Dnac configures below :
1) PKI
2)IPDT
3)HTTP server & SSH source
4) SNMP RO & RW community
When Telemetry configured for switch then below gets configured :
1) Syslog
2) SNMP traps
You need to configure the telemetry profile for optimal visibility .By default telemetry is disabled .
Cheers,
Dheeraj
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide