04-11-2024 02:36 AM
Cisco DNA GUI not working
and Checked by me
magctl appstack status : working
magctl appstack status | grep 0/ (no all working)
all Docker Container working
Cli wokring
maglev catalog package display (All Package deployed)
magctl service status (running)
Only issue GUI not wokring and not able see "DNA GUI not working"
04-11-2024 02:50 AM
Is this a fresh install/has the GUI been available previously? Does it respond to port 443 at all?
04-11-2024 10:59 AM
this is fresh installations and GUI not coming up
I tried 2 times but the issue same GUI not coming.
checked all kubelet conatiners,packakes all running fine. what issue can possiable
is there any DNS issue
04-11-2024 12:59 PM
Has the node been running for long after first boot? Takes quite a while for everything to come up fully.
Is this a hardware appliance install or virtual? Does it have the resources required?
04-11-2024 11:57 PM
When you installing DNAC First time , make sure you meet the pre-requisites, and DNAC required to access Internet to get packages
command line - maglev package status (make sure all ok before you get access to GUI)
depends on internet speed - it took for me 4 to 6 hours, some time a Day to complete whole installation)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide