09-25-2024 03:27 AM
I have a number of switch listed in Failed section on the Catalyst Center plug and play page.
Deleting them does nothing as they returns several minutes later.
All of them are fully configured but still seem to think they are in plug and play mode.
Does anyone know how to stop the plug and play process on the switches (without impacting the existing configuration)?
Thanks
Solved! Go to Solution.
09-25-2024 05:57 AM
The "pnp profile" config on your switches is what tells the PnP Agent on the switches to reach out to Cat Center. It can be safely unconfigured once PnP is complete.
09-25-2024 03:44 AM
Hello!
How are you running your pnp? Are you using DHCP? Does the switch still recive the DHCP? have you changed it manualy to a different management IP/VID?
PnP should really stop as soon as you configure the switch manualy. I never had any issues. Could you share the config?
BR
09-25-2024 05:57 AM
The "pnp profile" config on your switches is what tells the PnP Agent on the switches to reach out to Cat Center. It can be safely unconfigured once PnP is complete.
09-25-2024 06:18 AM
Many thanks. That seems to have done the trick.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide