Connect DNA Enterprise Port - 1Gbps

[Cisco1619]

I am trying to set up our lab DNA appliance but I don't have 10Gbps options. I saw in a document that the Enterprise port can run at 1Gbps. How do I do that? I have tried using a GLC-T but I haven't had any luck yet.

[Jonathan Cuthbert · Accepted solution]

The GLC-T/TE is not supported in either generation of the Cisco DNA Center appliance in the SFP+ ports. 

The ports only support 10Gbps transceivers. 

As a best practices, both SFP+ ports should be in the up/up state even for a single-node cluster. 

https://www.cisco.com/c/en/us/td/docs/cloud-systems-management/network-automation-and-management/dna-center/1-3-3-0/install_guide/2ndGen/b_cisco_dna_center_install_guide_1_3_3_0_2ndGen/b_cisco_dna_center_install_guide_1_3_2_0_M5_chapter_01.html#conce...

https://www.cisco.com/c/en/us/td/docs/cloud-systems-management/network-automation-and-management/dna-center/1-3-3-0/install_guide/1stGen/b_cisco_dna_center_install_guide_1_3_3_0_1stGen/b_cisco_dna_center_install_guide_1_3_2_0_M4_chapter_01.html#conce...