DNA Instalation

[MohssineBen]

I have a DNA center mounted as a standalone but in the configuration needs an ip for cluser (enp10s0), can someone please help me ?

[Tomas de Leon]

Please take a look at my worksheet and supporting documentation.  This should answer your questions.

                                                         TOTD: DNAC IP Address Planning Worksheet                  

Regards

T.

[bhose]

You can just give it any old IP address/network (i.e. 192.168.1.1/24) if you are using the appliance in standalone mode

[AndiBuchmann157]

the best way is to define this ip adress for future use. it doenst matter if you need it or not because adding / chaningig it later will be very hard / impossible. i would reccomend using something which can be used in the future and not "something like 192.168.1.1"

[nitekum5]

Please plan accordingly because you can’t change the IP later.

[vijha]

Hi,

You can skip configuring that adapter. In future are you planning for cluster or scalability?

Regards,

Vibha Jha

Cisco Sales Acceleration Center

sac-support@cisco.com