Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
583
Views
15
Helpful
1
Replies

DNAC Image Repository not using Proxy

trickyg
Level 1
Level 1

‎11-23-2021 04:20 AM

I am recently upgraded to DNAC v2.2.2.6 

 

I notice now that when I try and download image via Image repository it fails and (via TCPDUMP) have determined that this is due to the fact that it is not using the configured proxy and instead is attempting to connect directly to Cisco website.

 

Proxy config is OK and proved when I check DNAC Software Upgrades this goes via Proxy and works.

 

Is anyone else experiencing this behavior. It used to work fine in previous releases

Labels:
0 Helpful
1 Reply 1

trickyg
Level 1
Level 1

‎11-23-2021 09:20 AM

Found the issue - there is a setting EULA acceptance and this was unticked after the upgrade. Ticked and now uses the proxy for Image download

Customers Also Viewed These Support Documents

Review Cisco Networking for a $25 gift card