06-11-2021 08:53 AM
login page doesn't show up after reimaging it to 2.1.2.6 successfully with USB, error message says "{"message":"no route and no API found with those values"}", tried to reimage twice and facing same issue, did any one seen this issue?
Solved! Go to Solution.
06-11-2021 09:35 AM
Look at this thread may help you : ( some time it take Long time to get install all the packages)
06-11-2021 09:35 AM
Look at this thread may help you : ( some time it take Long time to get install all the packages)
06-14-2021 02:58 AM - edited 06-14-2021 03:04 AM
Thanks @balaji.bandi
By executing 'maglev package status' I noticed all those packages were in Not_Deployed status, after deploying system and platform-ui package by executing 'maglev package deploy system' , 'maglev package deploy platform-ui' , I was able to login with GUI, then I installed all other packages.
06-14-2021 06:38 AM
cheers all good, yes bit odd DANC stuff some time, ( i can understand the pain - none of the document mentioned how Long this take full installation in any cisco document).
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide