How to check DNAc is hardware or VM, it is cluster or not on gui

[palani2010]

How to check DNAc is hardware or VM, it is cluster or not on gui

[liviu.gheorghe · Accepted solution]

You can check if DNAC is hw or vm by going from the hamburger menu > System > System 360 > Service Explorer. Here hover with your mouse pointer over the DNAC cluster and you will see the serial number and product ID. A hardware DNAC is for example indicated by a product ID like DN2-HW-APL-U. 

You can verify also using the serial number and Device coverage site https://cway.cisco.com/sncheck/ in which you input the serial number and you get more details about your product.

For the cluster verification, go from the hamburger menu > System > Settings > System Configuration > High Availability where you can find info about your DNAC installation clustering configuration.

HTH