02-02-2020 06:58 AM - edited 02-02-2020 09:29 AM
Hi Techguys,
Any body have configured Layer 3 Etherchannel on Cisco 9300 with network essentials License.
switches model is. My assumpation is , its supports only Layer 2 etherchannel as of Layer 2 routed access port.
C9300-48P-E | Catalyst 9300 48-port PoE+, Network Essentials | C9300 Network Essentials, 48-port license |
Thanks in advance for your support
02-02-2020 11:54 PM
Hi,
L3 port-channels are supported in Network Essentials:
Switch#sh ver | in Smart License network-essentials Smart License network-essentials None Subscription Smart License None Switch#sh run int po1 Building configuration... Current configuration : 61 bytes ! interface Port-channel1 no switchport no ip address end
Can you advise what error / issue you are getting on your side?
Regards, Mariusz
02-03-2020 12:05 AM
Thanks Mariusz Kazmierski for the Reply,
I want to confirm as client wants Layer 3 etherchannle in access switches, it was not Supported in old LAN BASE Software.
Thanks for confirmation,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide