09-24-2024 09:29 PM
Regarding SNMP settings on the Catalyst 1300 switch,
it is different from the CLI commands for other 9000 series
but how do I set it up to send traps to an SNMP server?
I would be grateful if you could show me the specific commands.
This is a basic question, but please let me know.
Solved! Go to Solution.
09-24-2024 09:35 PM
Hello @kusajima-takayuki
Find the guide here:
09-24-2024 09:39 PM
Thank you for your answer.
Is it okay to set only the snmp-server community command?
Thank you in advance.
09-25-2024 11:34 PM
yes that should work, for i suggest for security reason use SNMPv3
If you using SNMPv2, then use only device required to contact switch to protect SNMP access from other devices.
You can also use ACL as example :
access-list 20 permit 10.10.10.10
snmp-server community RO 20 (if you need to give only Read Only)
snmp-server community RW 20 (if you need to give Read and Write Only - careful with read and write)
09-26-2024 10:13 PM
Thank you for your kind and easy to understand answer.
09-24-2024 09:35 PM
Hello @kusajima-takayuki
Find the guide here:
09-24-2024 09:39 PM
Thank you for your answer.
Is it okay to set only the snmp-server community command?
Thank you in advance.
09-25-2024 11:34 PM
yes that should work, for i suggest for security reason use SNMPv3
If you using SNMPv2, then use only device required to contact switch to protect SNMP access from other devices.
You can also use ACL as example :
access-list 20 permit 10.10.10.10
snmp-server community RO 20 (if you need to give only Read Only)
snmp-server community RW 20 (if you need to give Read and Write Only - careful with read and write)
09-26-2024 10:13 PM
Thank you for your kind and easy to understand answer.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide