SDA 1.0 to 2.0 Migration

[marookoilh]

We are migrating sda fabric from 1.0 to 2.0 , we have around 50 edge node and 2 bn/cp node , for the migration we need to remove fabric role of each devices and put back fabric role , is there any way to retain edge node configuration, don't want to reconfigure all edge nodes port again.

Can anyone give any tips and pointers?

[Haydn Andrews]

I take it the edge node ports are all static configured and not using ISE to identify the device and auto assign based on SGT.

One potential would be to get all the data of the current port config out of DNAC via APIs and then post migration use the APIs to push the config back - if all else fails

[jedolphi]

Hayden is correct! Some customers/partners have written scripts to read custom access port configurations from Catalyst Center APIs, write them to a DB, and then reprogram the custom access ports after Pub/Sub migration. Also, please be aware that there will be a Pub/Sub migration workflow in Catalyst Center that will be fully automated, if you can wait. I can't give a timeline in a public forum but your Cisco account team should be able to share some details. Best regard, Jerome