cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

702
Views
1
Helpful
4
Replies
Beginner

Error with Add-UcsCentralTagSoftwareInst cmdlet

Hello,

I'm attempting to run the following while connected to ucs-central utilizing PowerTool 2.2.1.8 :

Add-UcsCentralTagSoftwareInst -DefName "Operating System for HCR" -TaggedObjectDn "compute/sys-1009/chassis-1/blade-1" -Value "VMware vSphere 6.0 U2" -Vendor "VMware" -Version "vSphere 6.0 U2"


I get this error:

configured object (holder/tag-ep/type-Operating System for HCR-inst-VMware vSphere 6.0 U2-obj-compute/sys-1009/chassis-1/blade-1) not found



The target object DN does exist. Has anyone seen this or know how to resolve? Thanks in advance.

1 ACCEPTED SOLUTION

Accepted Solutions
Enthusiast

Re: Error with Add-UcsCentralTagSoftwareInst cmdlet

We just had a release of UCS PowerTool Suite last week. However this issue is still open with the latest release as well. At this point of time we don't have the exact schedule for the next release. You can expect a release sometime in May 2017.

Thanks,

Sumanth

View solution in original post

4 REPLIES 4
Enthusiast

Re: Error with Add-UcsCentralTagSoftwareInst cmdlet

There is an issue with the tagging related cmdlets in UCS Central PowerTool so currently you will not be able to perform this operation. We will be fixing this in the next release of PowerTool.

Thanks,

Sumanth

Beginner

Re: Error with Add-UcsCentralTagSoftwareInst cmdlet

Thanks Sumanth. Any ideas when the next version will be released?

Enthusiast

Re: Error with Add-UcsCentralTagSoftwareInst cmdlet

We just had a release of UCS PowerTool Suite last week. However this issue is still open with the latest release as well. At this point of time we don't have the exact schedule for the next release. You can expect a release sometime in May 2017.

Thanks,

Sumanth

View solution in original post

Highlighted
Beginner

Re: Error with Add-UcsCentralTagSoftwareInst cmdlet

Is this already resolved? I am struggelin with the same issue and error message with the latest UCS PowerTool version 2.5.1.6.

 

Any input is appreciated.

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here
This widget could not be displayed.