AnyConnect fails to connect to CML Sandbox
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-18-2022 06:02 PM
Hello,
AnyConnect fails to connect to CML Sandbox. Dring the connection attempt, AnyConnect is doing this:
but at the end, it times out and gives me two errors:
Laptop reboot, IPv6 disabled on the adapters did not help. Some of the settings on AnyConnect are:
Any idea is welcome. Thank you in advance.
- Labels:
-
Cisco Modeling Labs
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-09-2022 08:06 AM
Hi @NBenat,
That's strange. I just reserved the CML sandbox and AnyConnect worked fine to get me into the VPN.
It looks like you're on Window; shouldn't be a problem there. I'd make a new reservation of that lab and try again.
There is also a Cisco Community forum just for issues like this where you can search for answers, ask questions and open sandbox tickets: https://community.cisco.com/t5/devnet-sandbox/bd-p/4426j-disc-dev-devnet-sandbox
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-09-2022 02:23 PM
Thank you for your reply. I tried everything I could based on inputs form
the community, and things like reboot laptop, disable IPv6, uninstall,
re-install AnyConnect. None of that helped. I will, also suggested by Cisco
DeveNet, submit this issue to the proper forum.
