Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Team,I have a single hub, two spokes DMVPN Phase 1 topology but I can't get connectivity between the spokes. Any help is appreciated. Thank you in advance. The attached file shows with the spokes routing tables that they can't reach each other ...
Hello,AnyConnect fails to connect to CML Sandbox. Dring the connection attempt, AnyConnect is doing this:but at the end, it times out and gives me two errors: Laptop reboot, IPv6 disabled on the adapters did not help. Some of the settings on Any...
Hello,I have a three-router topology with all iBGP sessions in the Established state. A PC (10.1.1.100) is attached to R1's G0/0. The link between R1 and R2 is also up. Pings from R2 and R3 to 10.1.1.1 (R1 G0/0) are successful but pings from R2 an...
Hello,If try to start a from a CML Enterprise sandbox, I get "Starting lab failed. System is not licensed. I get a similar error when I try starting any node from any lab. I'm not sure this is a problem from my side. Any help is appreciated. Thank yo...
Struggling with this connectivity issue: Putty, Windows 10, ssh to sandbox-nxos-1.cisco.com, tried port 22 and 8181. I get a Putty fatal error: Network error: Connection timed out.An nslookup to sandbox-nxos-1.cisco.com does give me an IP address. Pi...
Hello Bigevilbeard,Never too late but you were on the right track. All AnyConnect routes in my Windows routing table had a gateway of 192.168.254.1 when they should have 192.168.1.254. Fixing this let me reach 10.10.20.161. Thank you so much.I still ...
An update: I was able to get the connection to 10.10.20.161 without having to uninstall NordVPN; I just disabled the automatic startup of NordVPN services, less painful than the uninstall. Which does prove the existence of a conflict between AnyConne...
Hello Bigevilbeard, that sounds like a great suggestion but unfortunately,I have no clue on how to implement it on my Windows laptop. Any furtherhelp will be appreciated. Thank you in advance
Hello, I have the same problem. I just found out that if I uninstall NordVPN, I can reach the lab platform at 10.10.20.161. Stopping the NordVPN process is not enough. It looks like NordVPN and AnyConnect create conflicting network adapters. That's h...
Hello Alexstev,Thank you for your reply. I tried everything I could based on inputs formthe community, and things like reboot laptop, disable IPv6, uninstall,re-install AnyConnect. None of that helped. I will, also suggested by CiscoDeveNet, submit t...
