Hi,
Last year I pass my CCNA exam and now I start to study for CCNP. I'm 60 year old but feel much younger. I just received my first new (old) LAB and I have
1 x Catalist 2950 (cable no.1)
1 x Catalist 3550 (cable no.2)
2 x Catalist 3560 Poe 24 (cable no.3 & No.4) (cable No. 8 in no use)
4 x Cisco 2600 router (cables No.5, No.6 and No.7 on router 2,3 and 4 respectively) My LAP connected with Router 1 (router with async ports).
and I have this Octal cable problem. I tried to config one of 2600 router (with 2 async ports 0-7 & 8-15) but without success. What I found from router config that I have async line 33 to 48 and cannot (or I don't know how) to change them.
Can someone be so kind to explain me cabling settings and R1 configuration so I can use LAB without switching console cable.
When I try to go to R2 from enable mode - here is result:
R1#r2
Trying r2 (1.1.1.1, 2033)... Open
s1#
Thank you
Bojan
