Here is the entire boot log.
3650-24# show log
Syslog logging: enabled (0 messages dropped, 1 messages rate-limited, 0 flushes, 0 overruns, xml disabled, filtering disabled)
No Active Message Discriminator.
No Inactive Message Discriminator.
Console logging: level debugging, 44 messages logged, xml disabled,
filtering disabled
Monitor logging: level debugging, 0 messages logged, xml disabled,
filtering disabled
Buffer logging: level debugging, 44 messages logged, xml disabled,
filtering disabled
Exception Logging: size (4096 bytes)
Count and timestamp logging messages: disabled
File logging: disabled
Persistent logging: disabled
No active filter modules.
Trap logging: level informational, 47 message lines logged
Logging Source-Interface: VRF Name:
Log Buffer (4096 bytes):
EL_INFO: HMAN-IOS channel event for switch 1: EMP_RELAY: Channel UP!
*Oct 9 13:39:47.223: %STACKMGR-1-STACK_LINK_CHANGE:Switch 1 R0/0: stack_mgr: Stack port 1 on switch 1 is nocable
*Oct 9 13:39:47.223: %STACKMGR-1-STACK_LINK_CHANGE:Switch 1 R0/0: stack_mgr: Stack port 2 on switch 1 is down
*Oct 9 13:39:47.223: %STACKMGR-1-STACK_LINK_CHANGE:Switch 1 R0/0: stack_mgr: Stack port 2 on switch 1 is nocable
*Oct 9 13:39:47.223: %STACKMGR-6-SWITCH_ADDED:Switch 1 R0/0: stack_mgr: Switch 1 has been added to the stack.
*Oct 9 13:39:47.223: %STACKMGR-6-SWITCH_ADDED:Switch 1 R0/0: stack_mgr: Switch 1 has been added to the stack.
*Oct 9 13:39:47.223: %STACKMGR-6-SWITCH_ADDED:Switch 1 R0/0: stack_mgr: Switch 1 has been added to the stack.
*Oct 9 13:39:47.223: %STACKMGR-6-ACTIVE_ELECTED:Switch 1 R0/0: stack_mgr: Switch 1 has been elected ACTIVE.
*Oct 9 13:40:10.013: %HMANRP-6-EMP_NO_ELECTION_INFO: Could not elect active EMP switch, setting emp active switch to 0: EMP_RELAY: Could not elect switch with mgmt port UP
*Oct 9 13:40:10.013: %HMANRP-6-EMP_NO_ELECTION_INFO: Could not elect active EMP switch, setting emp active switch to 0: EMP_RELAY: Could not elect switch with mgmt port UP
*Oct 9 13:40:10.052: %LINEPROTO-5-UPDOWN: Line protocol on Interface Lsmpi18/0/3, changed state to up
*Oct 9 13:40:10.063: %LINEPROTO-5-UPDOWN: Line protocol on Interface EOBC18/0/1, changed state to up
*Oct 9 13:40:10.063: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/0, changed state to down
*Oct 9 13:40:10.064: %LINEPROTO-5-UPDOWN: Line protocol on Interface LIIN18/0/2, changed state to up
*Oct 9 13:40:13.097: %IOSXE_MGMTVRF-6-CREATE_SUCCESS_INFO: Management vrf Mgmt-vrf created with ID 1, ipv4 table-id 0x1, ipv6 table-id 0x1E000001
*Oct 9 13:40:14.469: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan1, changed state to down
*Oct 9 13:40:22.441: %SYS-6-CLOCKUPDATE: System clock has been updated from 13:40:22 UTC Tue Oct 9 2018 to 07:40:22 CST Tue Oct 9 2018, configured from console by vty0.
*Oct 9 13:40:22.443: %SYS-6-CLOCKUPDATE: System clock has been updated from 07:40:22 CST Tue Oct 9 2018 to 08:40:22 CDT Tue Oct 9 2018, configured from console by vty0.
*Oct 9 13:40:24.738: %LINK-5-CHANGED: Interface GigabitEthernet0/0, changed state to administratively down
*Oct 9 13:40:32.738: %HMANRP-6-EMP_NO_ELECTION_INFO: Could not elect active EMP switch, setting emp active switch to 0: EMP_RELAY: Could not elect switch with mgmt port UP
*Oct 9 13:43:11.993: %PNP-6-PNP_DISCOVERY_STOPPED: PnP Discovery stopped (Startup Config Present)
*Oct 9 13:45:58.873: %SYS-5-CONFIG_I: Configured from memory by console
*Oct 9 13:46:02.994: %LINK-3-UPDOWN: Interface Vlan1, changed state to up
*Oct 9 13:46:04.582: %PLATFORM_PM-6-MODULE_INSERTED: SFP module inserted with interface name Gi1/1/3
*Oct 9 13:46:04.591: %SYS-5-RESTART: System restarted --
Cisco IOS Software [Denali], Catalyst L3 Switch Software (CAT3K_CAA-UNIVERSALK9-M), Version 16.3.7, RELEASE SOFTWARE (fc4)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2018 by Cisco Systems, Inc.
Compiled Fri 03-Aug-18 23:49 by mcpre
*Oct 9 13:46:04.610: %PLATFORM_PM-6-MODULE_INSERTED: SFP module inserted with interface name Gi1/1/4
*Oct 9 13:46:04.691: %SSH-5-ENABLED: SSH 1.99 has been enabled
*Oct 9 13:46:05.128: %SNMP-5-COLDSTART: SNMP agent on host 3650-24 is undergoing a cold start
*Oct 9 13:46:06.811: %SYS-6-BOOTTIME: Time taken to reboot after reload = 666 seconds
*Oct 9 13:46:08.220: %LINK-3-UPDOWN: Interface GigabitEthernet1/0/2, changed state to up
*Oct 9 13:46:09.227: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet1/0/2, changed state to up
*Oct 9 13:46:35.311: %SSH-5-DISABLED: SSH 1.99 has been disabled
*Oct 9 13:46:35.313: %SSH-5-ENABLED: SSH 1.99 has been enabled
*Oct 9 13:46:35.435: %SSH-5-DISABLED: SSH 1.99 has been disabled
*Oct 9 13:46:35.441: %SSH-5-ENABLED: SSH 1.99 has been enabled
*Oct 9 13:46:39.237: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan1, changed state to up
3650-24#
