Cisco Software Discussions

I've been tasked with ensuring our network devices are using approved ciphers, KEXs and MACs on our network devices.  How can I get a listing from Cisco Nexus 9K switches for each NXOS version?  Also, what about Firepower/FTD/FMC?  On a client, I can...

I am trying to change the LO1 ( RF1) input from default 5.15 to 10.75 (KU band).I have set all the tuning parameter correctly but I keep getting error when I click on apply  Problem Saving updatesUnable to SET value 10.75 Fail I even tried to perform...

Hi,  I have seen milestones for 16.9.x XE IOS at End-of-Sale and End-of-Life Announcement for the Cisco IOS XE 16.9.x - Cisco but I cannot understand why the 16.9.8 MD version was released in 2021 September the 1st if date of end of software support ...

Hello,We have a Cisco SDA fabric with 9300 edge switches and a single 9500 border node, with DNAC version 2.3.3.6-70045. The fabric in question contains a VN with native ASM multicast enabled in the overlay and an IP pool with Layer 2 flooding turned...

We have two port channel uplinks per FI. One goes to our ACI network and one goes to our Legacy network.Before ACI came along, we were just using VLANs (not VLAN groups) and no vlans were assigned to the port channel. Since we only up-linked to one n...

We aren't required to follow a certain direction, but I know 2 years ago NSA & NIST essentially said use 8 because 9 wasn't yet vetted. Cisco had or does recommend type 9. What did you go with?Finally upgrading from the ones you can just paste and se...

Hello!I am writing here, as I have a Cisco UCS C220 M3 server, which has been out of support and after end of life for a couple of years already (https://www.cisco.com/c/en/us/obsolete/servers-unified-computing/cisco-ucs-c220-m3-rack-server.html).As ...

is cisco ucs central 2.0(1t) has End of support date?

Hey there!I'm trying to upgrade a NX OS 9000 93108TC-FX from version 7.0(3)I7(3) to 7.0(3)I7(10) in order to upgrade it eventually to 10.2(6)When running `show install all impact nxos bootflash:nxos.7.0.3.I7.10.bin` I receive:Module  |bootable   |Imp...

Hi all,I am unable to ping the switches from distribution to the access switches.What could be the problem?Kindly see attached PKT file from packet tracerI would be grateful for any help.Configurations on the DISTRIBUTION SWITCH is :Current configura...

Hey there fellows.I have a Cisco Nexus 93108TC-FX Switch in version 7.0(3)I7(3) and I want to upgrade it (finally).But I'm unable to find the GA. I have tried looking the Software Download Center but there is no GA indication there.Is there a way to ...

Hello, everyone.This issue arises when the device is powered off. Consequently, upon powering it back on, it fails to boot automatically and becomes stuck in ROMmon mode, requiring manual intervention via the boot command to access the CLI.The proble...

Hello  Can we directly upgrade from 16.9.5 to 16.12.10a MD for C3850? or any intermediate upgrade path is required? Kindly help me with an answer @cisco  

I have Cisco 3850-48P-E V04 switch with a lost password. I have tried to reset the passoword and tried to abort the boot process. but none of the mentioned methods don't abort the process. it keeps booting till the place where we enter username/passw...