Hello. I have a question. Is there a way to configure the image of the devices (such as routers and switches), that whenever I bring them into my lab, they have a start-up config same as the one I configured them with. Like I don't want to configure "logging synchronous" on each and every router every time I set them up for my labs. Is there a way to embed this command permanently into the device's image ?
Solved! Go to Solution.
I upgraded to 2.6 so not entirely sure how much difference there is with 2.5 wrt the node definition page, but with 2.6 there is a Read-Only toggle switch at the top of the page. Might be there for 2.5 as well, but I do not remember. Also, even with Read-Only disabled, there is a an "Editable" toggle in the provisioning section.