CML2.7のcat9000vのOpenFlow有効化の方法について

[Kyozin0514]

CML2.7のcat9000vを使ってSDN環境を構築するために，cat9000vのOpenFlowを有効化をしたいがやり方が分からないので教えてください。

[Torbjørn]

Openflow mode is unfortunately not yet supported on the Cat9kv. You can either submit this feature request with your Cisco contact or post it to the CML Personal community on CLN: https://learningnetwork.cisco.com/s/topic/0TO3i00000094ZjGAI/cisco-modeling-labs-personal-community

[Kyozin0514]

Thank you for your response. I was able to understand.

By the way, what features are available on Cat9kv?

[Torbjørn · Accepted solution]

I am unfortunately not aware of any complete list of available features on the Cat9kv. You can find the list of tested features in the following documentation: https://developer.cisco.com/docs/modeling-labs/cat-9000v/#cat-9000v. Other than these you'll just have to experiment with what will work and not.

Note that it is still a Beta image, so you shouldn't rely too much on it behaving the same as other Cat9k switches.