cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
804
Views
0
Helpful
5
Replies

File flash:crashinfo_20220421-043234 Device Error :No such device

Ibrohim
Level 1
Level 1

my router not working. it reloading without stop and giving that message "%Software-forced reload" "File flash:crashinfo_20220421-043234 Device Error :No such device".

I changed Flash to another one , but problem same.
what i need to do ...

5 Replies 5

balaji.bandi
Hall of Fame
Hall of Fame
: %ESWMRVL_FLTMG-5-WARNING: Warning: ILP HW Init failed
: %ESWMRVL_FLTMG-7-INTERNAL_ERR: Internal error:

is the device boot or stuck at ROMMON or keep rebooting ?

 

Power down the router - remove any modules installed and boot 

 

Post complete boot (not screenshot please)

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

booting periodical 

 

System Bootstrap, Version 12.4(11r)XW3, RELEASE SOFTWARE (fc1)
Copyright (c) 2007 by cisco Systems, Inc.

​‌C1860 series platform with 262144 Kbytes of main memory

​‌Readonly ROMMON initialized

​‌program load complete, entry point: 0x80015000, size: 0xb700

​‌program load complete, entry point: 0x80015000, size: 0xb700

​program load complete, entry point: 0x80020000, size: 0x264531c

​‌Self decompressing the image : ################################################################################################################################################################################################################################################################################################################################################# [OK]

​‌Smart Init is enabled

​‌smart init is sizing iomem

​‌ID MEMORY_REQ TYPE

​‌0X00135430 Onboard PVDM2 SIMM

​‌0X00003960 Onboard Ethernet

​‌0X0011D000 Onboard VPN

​‌0X000F3BB0 public buffer pools

​‌

0X00703000 public particle pools

​‌

TOTAL: 0X00A4C940

​If any of the above Memory Requirements are

​‌"UNKNOWN", you may be using an unsupported

​‌configuration or there is a software problem and

​‌system operation may be compromised.

​‌Rounded IOMEM up to: 10Mb.

​‌adjusted iome size up to minimum size of: 0X00C00000

​‌Using 4 percent iomem. [12Mb/256Mb]

Hope this was working before ? May be worth reset to factory and try again ?   get in to ROMMON / Format the flash - get IOS from TFTP

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

how can i reset it? it doesn't working properly .
has any option reset in rommon mode?

i changed flash but no effect