cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
930
Views
0
Helpful
2
Replies
Highlighted

How do you configure the monitor capture command? Fuji Version 16.09.05

Trying to configure monitor capture, but commands that used to work on older IOS are coming up invalid.

monitor capture buffer NMSBUFF size 50000 linear

monitor capture buffer NMSBUFF filter access-list NMSCAPTURE
monitor capture point ip cef NMSPOINT GigabitEthernet0/1/0 both
monitor capture point associate NMSPOINT NMSBUFF

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
VIP Mentor

Re: How do you configure the monitor capture command? Fuji Version 16.09.05

Look at the example and syntax  and order of operation :

 

https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/epc/configuration/xe-16-9/epc-xe-16-9-book/nm-packet-capture-xe.html

BB
*** Rate All Helpful Responses ***

View solution in original post

2 REPLIES 2
Highlighted
VIP Mentor

Re: How do you configure the monitor capture command? Fuji Version 16.09.05

Look at the example and syntax  and order of operation :

 

https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/epc/configuration/xe-16-9/epc-xe-16-9-book/nm-packet-capture-xe.html

BB
*** Rate All Helpful Responses ***

View solution in original post

Highlighted

Re: How do you configure the monitor capture command? Fuji Version 16.09.05

Thank you, yes this was very helpful.

CreatePlease to create content
Content for Community-Ad

Cisco COVID-19 Survey