Paste configuration failed on ASA5555 command line

[lenovo_lcadmin]

I'm facing a issue when paste access-list configuration in ASA5555 command line.

The "space character" will gone at the end of command near by "eq".

This is the configuration waiting for paste:

And this is the output with using SecureCRT after paste:

I also try in SSH:

Some information of device:

agralwebvpn5555X-01# show ter

Width = 100, no monitor
terminal interactive
agralwebvpn5555X-01# show pager
no pager
agralwebvpn5555X-01# show ver | i Version
Cisco Adaptive Security Appliance Software Version 9.8(4)25
Firepower Extensible Operating System Version 2.2(2.124)
Device Manager Version 7.12(2)
Baseboard Management Controller (revision 0x1) Firmware Version: 2.4
agralwebvpn5555X-01#

[balaji.bandi]

I have not verified the syntax.

what is the outcome if you type single line manually (instead of copy and paste ) ?

[lenovo_lcadmin]

input manually is working, but paste failed

[balaji.bandi]

Try with Putty ?  is the same issue ?

what version of Secure CRT ?

[lenovo_lcadmin]

Putty(ver 0.74) not working, putty's output same as SSH, SecureCRT version is 8.7.3

[balaji.bandi]

is this notepad or notepad ++ , you copy from ?

[lenovo_lcadmin]

Notepad, native program from windows 10

[balaji.bandi]

try other suggest advise please.

[TJ-20933766]

That is strange that your white spaces at the end of each ACL was deleted during your paste. When you copied from the original ASA, did you paste it into a Microsoft word document, OpenOffice, or some other word processing program first and then copied the text from that document to the new ASA? It's about the only thing I can think of that might mess with the formatting of your commands. I typically just use notepad for any scratch work since it doesn't mess with any formatting.

[lenovo_lcadmin]

these command copied from notepad too : -P

It's non-formatting

I have confirmed many times

[balaji.bandi]

Not sure this solve or not, lets try what is your VTY Lines config (can you post the config)

try below :

Options 1 :

try Line con and vty add below line and test it.

stopbits 1

Options2 :

terminal width 500

test and advise.