
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-09-2014 01:35 PM - edited 03-17-2019 04:27 PM
Disable "send usage data to cisco" on install of jabber for windows default.
for some reason on 10.5.0 this is enabled by default, can we disable this via command line? or msi transform?
Solved! Go to Solution.
- Labels:
-
Jabber
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-10-2014 06:30 AM
Hey Chris.b.carlson,
Currently, the only way to disable it is by creating an xml file with the parameter:
<Policies> <TelemetryEnabled>False</TelemetryEnabled> </Policies>
The xml file will be applied when the application launches.
Hope this helps.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-10-2014 06:30 AM
Hey Chris.b.carlson,
Currently, the only way to disable it is by creating an xml file with the parameter:
<Policies> <TelemetryEnabled>False</TelemetryEnabled> </Policies>
The xml file will be applied when the application launches.
Hope this helps.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-10-2014 12:53 PM
in the jabber-config.xml ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-20-2015 12:27 PM
Is there a downside keeping this enabled? Will the Jabber client send usage data to Cisco automatically?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-23-2015 08:52 AM
yeah that is what it says :)
