cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1275
Views
0
Helpful
2
Replies

Does anyone else have an issue dialing a Polycom HDX from a Spark Room 55?

DarrenBurch
Level 1
Level 1

Hi,

We haven recently obtained a couple of Spark Room 55, and when we try and connect to some of our legacy codecs (Polycom HDX8000) via our VCS, the Spark seems to think that content is being shared and reduces the far end camera image and shows a blank content page.

it does it on both our Spark Rooms and no setting on either side seems to help

Any ideas?

Thanks

1 Accepted Solution

Accepted Solutions

This is a known bug when interworking SIP to H323 on some Polycom devices.

Try upgrading the Spark Rooms to CE9.2.2 and make sure the Polycom is running the latest software.  It also may be worth trying to register the Polycom endpoint as SIP.

View solution in original post

2 Replies 2

This is a known bug when interworking SIP to H323 on some Polycom devices.

Try upgrading the Spark Rooms to CE9.2.2 and make sure the Polycom is running the latest software.  It also may be worth trying to register the Polycom endpoint as SIP.

Thanks for this info.

We can't run the latest Polycom firmware, but upgrading to CE9.2.2 or registering the Polycom to SIP did the trick.

Thanks again