06-13-2013 10:32 AM - edited 03-17-2019 03:18 PM
Hi,
I CUCM and IM and Presence 9.1 installed and integrated with AD. I am able to see users imported from AD to CUCM and IM and Presnce Server.
I have the follwowing configured but Jabber not able to see other AD users.
1. CSF Profile
2. End User Associated with CTI enabled and CCM End user rights.
3. Users imported from CUCM, and in CUCM from AD
4. Able to login on Cisco Jabber for Windows.
5. UC Service for CTI, Voicemail, Directory is created
6. Service Profile is created with appropriate UC services
7. After Login on Jabber if I see Jabber Status, CTI Connected, VM Conneced, Direcotry "Unknown"
Can any came across with similar problem
Regards,
Amritesh Anand
06-13-2013 11:24 AM
Have you configured the jabber-config.xml file pointing to the right OU?
If you haven't configured the file, it's all in the deployment guide.
HTH
java
if this helps, please rate
www.cisco.com/go/pdihelpdesk
06-13-2013 11:27 AM
Hi Jamie,
Thanks for the reply.
Is it needed if you have already integrated the CUCM with with AD and imported the users from search base.
Regards,
Amritesh Anand
06-13-2013 11:28 AM
Just to add the above issue. My CSF profile is also not registered even though I am logged in to Jabber.
Also Show Connection Status on Jabber is as follow
CCMIP- Not Connected (I am able to ping CUCM Server)
Directory - Unknow
CTI- Success
Softphone - success
06-13-2013 11:53 AM
Yes, it's all explained in the configuration guide.
You need to configure the .xml file.
You can log into IM&P but not into CUCM, I'd recommend you to carefully review your configuration against the config guide.
HTH
java
if this helps, please rate
www.cisco.com/go/pdihelpdesk
06-13-2013 11:57 AM
Sure, will do.. I found another reason which would have causes the problem.
My AD is 2013 and CUCM and IM and Presence only support until 2008.
I will try to move to 2008 and see if this problem exists.. will let you know once done.
I still have another issue open. Why is my CSF profile unknown.
End user have CTI Enabled and Starndard CCM End user access
Device Selected in end user with Primary extension
End user associated in IP Phone and CSF profile as well as owner user id.
Still when I login it is not registering. I am using softphone mode
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide