Hi
Does Jabber for windows support video calling in deskphone mode? I have 7942 IP Phone, VT advantage camera on Laptop and Jabber clinet insatlled on laptop. Can i make video callng with Jabber in Deskphone mode?
It is not working please help.
Regards,
Andy
Solved! Go to Solution.
Hi Andy,
Yes, Jabber for Windows supports video calling in deskphone mode.
You'll need to install the Cisco Media Service Interface specific to your version of Jabber and correctly configure Jabber for Deskphone Video.
Please follow these instructions to configure Deskphone Video:
Once completed, if you run Jabber you should see the following when you open the Connection Status window (Help > Show connection status):
Regards,
Matt
Hi Anderssson,
Yes, Jabber for Windows supports video call in Deskphone mode (where Jabber is CTI controlling the deskphone - which transmits the audio and the video is via the PC). The PC must be tethered to the phone and the additional (medianet / cdp) msi installed for deskphone video to operate (not required for Softphone or when Jabber is simply in CTI deskphone control mode with no media on the PC.
Phone must be video-enabled in CUCM, and if phone is a video phone then camera has to be removed.
Deskphone video works in the 7900 series of phones using SCCP only. It is not supported with SIP on these phones
Further details on these features are available in “Set Up Unified Communications” section in Admin guide.
Regards,
Nebojsa
Hi Andy,
Yes, Jabber for Windows supports video calling in deskphone mode.
You'll need to install the Cisco Media Service Interface specific to your version of Jabber and correctly configure Jabber for Deskphone Video.
Please follow these instructions to configure Deskphone Video:
Once completed, if you run Jabber you should see the following when you open the Connection Status window (Help > Show connection status):
Regards,
Matt
Hi Anderssson,
Yes, Jabber for Windows supports video call in Deskphone mode (where Jabber is CTI controlling the deskphone - which transmits the audio and the video is via the PC). The PC must be tethered to the phone and the additional (medianet / cdp) msi installed for deskphone video to operate (not required for Softphone or when Jabber is simply in CTI deskphone control mode with no media on the PC.
Phone must be video-enabled in CUCM, and if phone is a video phone then camera has to be removed.
Deskphone video works in the 7900 series of phones using SCCP only. It is not supported with SIP on these phones
Further details on these features are available in “Set Up Unified Communications” section in Admin guide.
Regards,
Nebojsa
Hi
do you have an idea of how the camera is removed on a Cisco 8945 Phone?
Regards,
Christoph