Jabber not working on Guest Network (Meraki)

[danwordswrth]

Hi All,

At current Jabber works from our internal network. IT should also work externally.

I am trying to get our guest network to work also. On Meraki the guest network that is on their private /8 NAT'd network, i have created static routes/allows in the ACL for traffic going to all of the ExpressE/C gateways as well as the CUCM etc. Now i am able to succesfully authenticate and sign in. I am able to make both internal and external calls..however the voice does not work on either end.

Is this an encapsaluation issue, does anyone have any ideas? Thanks!

Thanks

David

[danwordswrth]

Here is the NAT mode on Meraki DHCP (Guest Network)

• Clients receive IP addresses in an isolated 10.0.0.0/8 network. Clients cannot communicate with each other, but they may communicate with devices on the wired LAN if the SSID firewall settings permit.