This document was generated from CDN thread
Created by: Ricardo Casas on 15-02-2011 12:57:26 PM
Hi
I have a C40 codec.
I make the audio changes with the TC Console, but when I remove the power supply to the codec then the codec lose all changes made with the TC Console.
I have another C40 codec and don't lose the changes made with the TC Console.
Regards
Ricardo.
Subject: RE: TC Console don't saves the changes permanently
Replied by: Viggo Fredriksen on 16-02-2011 12:13:14 PM
Hi,
when pulling the power from the codec, there are no guarantees that changes are physically written to the internal flash drive. After doing such changes you should always boot the codec gracefully.
Regards,
Viggo
Subject: RE: TC Console don't saves the changes permanently
Replied by: Ricardo Casas on 21-02-2011 04:28:49 PM
Hi,
What do you want to say with "boot the codec gracefully"?
Can I restart the codec with a "xcommand boot" command?
Regards
Ricardo.
Subject: RE: TC Console don't saves the changes permanently
Replied by: Roger Boe on 21-02-2011 04:33:26 PM
Hi Ricardo,
Yes, you can. Gracefully means not to pull out the power plug or shutting down the codec using the power switch. Any other reboot will be fine.
Best regards
Roger
Subject: RE: TC Console don't saves the changes permanently
Replied by: Ricardo Casas on 22-02-2011 06:09:01 PM
Hi,
That was the problem. Now all is OK.
Thanks.
Ricardo.
