Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Create a new article
4932
Views
0
Helpful
0
Comments

How to configure a DSP farm for conferencing and transcoding services with the PVDM-256K on Cisco 1751 or Cisco 1760 series routers

TCC_2
Level 10
Level 10

‎06-22-2009 05:26 PM - edited ‎03-12-2019 08:57 AM

Resolution

To configure the Digital Signal Processor (DSP) farm for conferencing and transcoding services, perform this procedure:

Note: First, issue the show voice dsp command to determine that there are enough DSPs available for conferencing and transcoding services.

  1. Issue the enable command.
  2. Issue the configure terminal command.
  3. Issue the dspfarm confbridge maximum sessions number command.
  4. Issue the dspfarm      transcoder maximum sessions number command.
  5. Issue the dspfarm command.
  6. Exit the Command Line Interface (CLI).

For more details, refer to Configuring Enhanced Conferencing and Transcoding for Voice Gateway Routers.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents