on 01-24-2014 01:48 PM
Hi all,
I try to send DTMF tones during a call to control door opener behind ata187.
i register service and put the service on a button on the phone.
xml file lokks like this:
<CiscoIPPhoneExecute>
<ExecuteItem Priority="0" URL="Key:KeyPadPound"/>
<ExecuteItem Priority="1" URL="Key:KeyPad1"/>
<ExecuteItem Priority="1" URL="[url=http://some-ip/tuer6.xml"/]http://some-ip/tuer6.xml"/>
</CiscoIPPhoneExecute>
as long as the the request lasts no dtmf tone is sent.
can someone help me?
has someone a simple solutioon?
Thanx in advance.
Martin
Can you elaborate a bit more on the scenario? Is the phone assumed to already be in a call to the ATA?
Note, that you will need to use the SendDigits: URI to send in-call DTMF...please see the developer docs for details. Also note that SendDigits is not supported on all firmware versions for 69xx series...what firmware load is running?
Can you elaborate a bit more on the scenario? Is the phone assumed to already be in a call to the ATA?
Note, that you will need to use the SendDigits: URI to send in-call DTMF...please see the developer docs for details. Also note that SendDigits is not supported on all firmware versions for 69xx series...what firmware load is running?
Information about how to use the SendDigits URI can be found here:
http://www.cisco.com/en/US/docs/voice_ip_comm/cuipph/all_models/xsi/7_0/engl
ish/programming/guide/xsi70uri.html#wp1052545
I think that SendDigits can only be used in an CiscoIPPhoneExecute object.
HI Martin,
Have you got your questions solved? I am experiencing a similar issue as you did, you can find the information about my case here: How to send PIN when making a call using SendDigits?The difference is that I receive a "No Active Call" response while you receive a "URI not found" response.
Appreciate a lot if you can share your solution.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: