This document was generated from CDN thread
Created by: Francesc Mas on 13-04-2011 10:40:02 AM
Dear Sirs:
Tandberg C20 works perfectly with:
GEFEN component analog converter ( RGB ) - HDCP compliant
Modern TFT Monitors - HDC compliant.
TV's - HDCP compliant.
Tandberg C20 does not work with:
Matrox DVI Convert Plus (HD-SDI) - non HDCP compliant
Old TFT monitor like HP 2025 - non HDCP compliant.
Some test TV's we have in our laboratory - non HDCP compliant ones.
If we connect Tandberg C20 to a HDMI distributor, with two HDMI outputs, we have leds to show if every output is working. When we connect a non HDCP compliant equipment to the distributor, after about 6 secons, the distributor led will switch off to indicate the HDMI stops because it's not HDCP compliant.
So it's evident that Tandberg C20 HDMI output has HDCP.
We wish to know how can we stop HDCP in both HDMI outoputs.
Best regards,
Francesc Mas
+34934999438
