When calling a CRA script that has been assigned to a route point and set to a language, callers do not hear any prompts

[TCC_2]

Core Issue

The script is invalid or the language to which the script has been set was not installed successfully.

Resolution

To resolve this issue, perform these steps:

1. Validate the script.
2. Set the language at the route point to en_US and verify that the script operates correctly.
3. If the script does not operate correctly, perform these steps:
   1. From the Cisco Customer Response Applications (CRA) Administration web page, choose System > Engine, click the Trace Configuration hyperlink and then check the Debugging check boxes for the LIB_MEDIA and the SS_TEL subfacilities.
   2. Run the script again and refer to the CRA trace files.
   3. If prompt exceptions appear in the CRA trace files, reinstall the desired language.

For more information about resolving Cisco CRA and Customer Response Solutions (CRS), refer to these documents:

• Diagnosing and Correcting Cisco CRA Problems
• Cisco IPCC Error Codes

Problem Type

Voice applications (CRS, PA, CCM Plugins, CER, CCC, MeetingPlace, etc.)

Voice quality problems (Audio quality: Choppy voice, hissing, echo, etc.)

Voice Quality

Absolute silence (Listen to short or long absolute silence samples.)

Failure Type

Bad operational behavior

Nothing plays: Missing tone, music, greeting, prompt, message, announcement, etc.

When Problem Occurs

Part of IVR dialog

Computer Telephony Integration (CTI) Port

CTI route point

Customer Response Solution (CRS) Version

CRS 3.x

Customer Response Solution (CRS) Applications

IP interactive voice response (IP IVR)

Customer Response Solutions (CRS) Concepts

Route point trigger

Customer Response Solutions (CRS) Script Applications

Language prompt

CRA script

CRA prompt

Voicemail, Conference, CRS/IPCC, Autoattendant and TTS/ASR Functions

Language

Spoken prompts

Voice Applications

Customer response applications