CRA Active Directory Setup (failover)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-31-2006 10:47 AM - edited 03-13-2019 11:49 PM
Hello,
CRA 3.5(3) environment. Active Directory Setup, pointed to Sub first, Pub second. When we pull the Sub, failover does not work. The Pub registers all of the IP devices except the IVR functionality. IVR cannot talk to the Pub Directory. IP addresses on same subnet and both ip addresses are configured under Subsystem Jtapi and ICD configuration.
Backup utility puts out a warning that Publisher is not integrated with DC Directory, but we are using AD.
Any ideas or thoughts. THank you in advance.
- Labels:
-
Other Contact Center
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-06-2006 11:15 AM
This URL should help you:
http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00801786cb.shtml
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-06-2006 03:14 PM
Yes..This is very helpful. It looks like much effort. I wish I could just add the secondary IP address under Configuration & Repository and cycle the Engine and it would work. Would make my life much easier...ha.