cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
404
Views
0
Helpful
2
Replies

CVP G711 transcode issue

p.horwood
Level 1
Level 1

Has anyone tried to set up internal calls i.e. from an IP Phone to CVP. CVP only talks G711 but the IP Phone is talking G729 so transcoding resource is required. MTP need to be checked but then all calls tie up transcode resource

2 Replies 2

wadegong
Level 1
Level 1

Cisco gateway does support G729 and CVP too.

You need to define voice class codec.

However, only G711 is supported if using CVP VB as endpoint, and the ASR/TTS vendors currently only support g711ulaw for voice recognition and synthesis.

Also check out this page (http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_configuration_example09186a00803f8950.shtml)

thanks

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: