New MAC adress

[DefJacques]

Is it possible to change the MAC address of a Cisco EPC3925 to renew your IP address?

And if, how do I do this?

The only thing I can do to use a different IP is changing from Router Mode to Bridge Only and then run the computers ip, but when I want to go back to Router Mode, then I have to reset gateway, as there are limited options in Bridge Only

Greetings John

[dbgdejong]

I've got a almost simelar problem, like John;

My ISP has blocked some options of my Cisco EPC3925 router. I'm not able to change the Connection Mode.

The Connection mode is set to 'DHCP' and blocked for changing. I would like to renew my WAN IP address...

I contacted my ISP but they could not help me refreshing my WAN IP address, nor to release the protection of this option.

Anyone suggestions how to release/renew or refresh my WAN IP address while this Connection Mode option is blocked?

Maybe a external command??

By the way: Powering of the router and wait for 24 hours turning it on again did not resolve the problem...

Thanks in advance!