07-28-2016 03:04 PM - edited 03-01-2019 04:30 AM
Hi,
I am trying to deploy IWAN using apic em (in lab environment).
My hub site is deployed successfully. But when I am trying to deploy branch site, it gives me "ERROR_DURING_TRUSTPOINT_PROVISIONING" error.
Any suggestions. Is there any troubleshooting document available for apic em?
Following config is being loaded in router (ISR4451-X/K9) when checked under PnP tab -
username admin privilege 15 password 0 cisco
enable password cisco
line vty 0 15
transport input ssh
transport output ssh
login local
exit
ip domain name test.com
snmp-server community public RO
snmp-server ifindex persist
crypto ikev2 disconnect-revoked-peers
end
Thanks,
vish
Solved! Go to Solution.
08-29-2016 11:27 AM
HI,
Figured out the problem. The security licenses were not enabled on the device.
Thanks,
Vish
08-05-2016 03:29 AM
Hi Vishal,
Can you - Navigate to the Site Status page and click the Recovery icon. If Unable to revert configuration on devices. Please restore site manually before re-provisioning.
This is the url :-Software Configuration Guide for Cisco IWAN on APIC-EM - Backup, Restore, and Recovery [Cisco Application Policy Infrast…
Thanks and Regards,
Geevarghese
08-29-2016 11:27 AM
HI,
Figured out the problem. The security licenses were not enabled on the device.
Thanks,
Vish
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide