11-10-2015 11:33 AM - edited 03-01-2019 04:25 AM
I just installed the GA version of the APIC-EM and it seems to install correctly runs through the wizard and everything but after the services start the Web UI does not load I don't see the webpage at all. We had the CA2 release previously on this VM and it worked like a charm, has anyone else seen this issue or have any ideas? I have tried blowing away the VM and starting over but same result.
Thanks,
Adam !
Solved! Go to Solution.
11-10-2015 11:47 AM
Is your UI service running ?
You can check it out by going to https://controllerIP:14141 (port 14141) use the same credential as you login to your UI.
11-10-2015 11:47 AM
Is your UI service running ?
You can check it out by going to https://controllerIP:14141 (port 14141) use the same credential as you login to your UI.
11-10-2015 11:54 AM
So I can login and this is what I see under UI
ui | 0.9.5.2081 | 50 | https | / | / | 9000 |
how do I know if it is running? Sorry I am a newbie to this stuff
11-10-2015 12:05 PM
Is it green and say running at the bottom ? choose overview view.
11-10-2015 12:19 PM
It looks like most of the services were not turned on so I am growing them now we will see if that fixes it.
11-10-2015 12:31 PM
That did it thanks for you help it works now.
11-10-2015 12:53 PM
11-17-2015 10:12 AM
Hello,
I got the same problm. This is the first time I installed APIC-EM and now I started every avilable service manually.
Is it correct that every service must be up and running ?
Best regards,
Steffen
11-17-2015 10:45 AM
We should see all services are running after a successful installation. It's better to get all services running. Make sure to allocate enough memory,cpu and storage when we install it
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide