Hello Experts
we are new to DCNM and also using DCNM to building a new VXLAN with nexus 9K
we need to have a use case to create HSRP on the SVI, since DCNM not allowed us to do freedom config in NETWORKS, I tried to apply like normal like below, however DCNM found it is not standard and ask to remove by issuing "no int vlan XXX" and the interesting begin, I see HSRP is still working but I cannot found any CLI prompt
I tried to reboot and HSRP still exist, my NX-OS version is 9.3.3 is that some special feature that new in NX-OS 9.3? that leading a problem if the CLI is not 100% of all configuration.
int vlan ####
hsrp 1
ip x.x.x.x ....
NX15# sh hsrp brief
*:IPv6 group #:group belongs to a bundle
P indicates configured to preempt.
|
Interface Grp Prio P State Active addr Standby addr Group addr
Vlan1 1 50 P Active local unknown X.Y.200.1 (conf)
Vlan9 1 50 P Active local unknown X.Y.9.1 (conf)
Vlan50 1 50 P Active local unknown X.Y.50.1 (conf)
Vlan194 1 50 P Active local unknown X.Y.194.1 (conf)
Vlan254 1 50 P Active local unknown X.Y.254.17 (conf)
Vlan256 1 50 P Active local unknown X.Y.254.129 (conf)
Vlan257 1 50 P Active local unknown X.Y.254.33 (conf)
Vlan258 1 50 P Active local unknown X.Y.254.49 (conf)
Vlan401 1 50 P Active local unknown X.Y.129.1 (conf)
Vlan405 1 50 P Active local unknown X.Y.130.1 (conf)
NX15# sh run | i X.Y.129.1
NX15# sh run | i hsrp
feature hsrp
hsrp 1
hsrp 1
NX15# sh ver | i upti
Kernel uptime is 0 day(s), 0 hour(s), 5 minute(s), 7 second(s)
NX15# sh st | i hsrp
feature hsrp
hsrp 1
hsrp 1
NX15# sh ver | i upti
Kernel uptime is 0 day(s), 0 hour(s), 6 minute(s), 6 second(s)
NX15#
