I'm not sure why, but I've always had trouble deciphering which commands to use to show the packets in the CLI as they pass through the switch, matching my filter.
Basically, I want to show packets that match my filter right there in the CLI.
Is this the correct usage?
ethanalyzer local interface inband display-filter ip.addr==1.2.3.4 limit-captured-frames 20
Capturing on inband
0 packets captured
I'm troubleshooting an issue, so I'm not sure if the packets aren't entering my switch, or if I have the filter wrong.
Not sure why I have trouble with this every time I try to use it.
Thanks in advance!