Nexus 3172 upgrade firmware failed

[slakos]

switch# install all nxos bootflash:nxos.9.2.2.bin

Installer will perform compatibility check first. Please wait.

Installer is forced disruptive

Verifying image bootflash:/nxos.9.2.2.bin for boot variable "nxos".

[####################] 100% -- SUCCESS

Verifying image type.

[####################] 100% -- SUCCESS

Preparing "nxos" version info using image bootflash:/nxos.9.2.2.bin.

[####################] 100% -- SUCCESS

Preparing "bios" version info using image bootflash:/nxos.9.2.2.bin.

[####################] 100% -- SUCCESS

Collecting "running" plugin(s) information.

[####################] 100% -- SUCCESS

Collecting plugin(s) information from "new" image.

[####################] 100% -- SUCCESS               [####################] 100% -- SUCCESS

Performing module support checks.                    [####################] 100% -- SUCCESS

Notifying services about system upgrade.             [####################] 100% -- SUCCESS

Compatibility check is done:

Module  bootable          Impact  Install-type  Reason

------  --------  --------------  ------------  ------

     1       yes      disruptive         reset  default upgrade is not hitless

Images will be upgraded according to following table:

Module       Image                  Running-Version(pri:alt)           New-Version  Upg-Required

------  ----------  ----------------------------------------  --------------------  ------------

     1        nxos                               7.0(3)I7(9)                9.2(2)           yes

     1        bios                        v5.3.1(05/17/2019)    v5.2.0(05/18/2018)            no

Switch will be reloaded for disruptive upgrade.

Do you want to continue with the installation (y/n)?  [n] y

Install is in progress, please wait.

Performing runtime checks.                           [####################] 100% -- SUCCESS

Setting boot variables.

[###########         ]  50% -- FAIL.

Return code -1.

Install has failed. Return code 0x4093000C (Setting boot variables failed).

Please identify the cause of the failure, and try 'install all' again.

[slakos]

After restart I have below crash:

Press TAB in 1 seconds to list all boot options

Any other key to active boot...

Press  ctrl L to go to loader prompt in 2 secs

Booting kickstart image: bootflash:/nxos.9.3.7.bin

CardIndex = 11091

Image valid

MD5Sum mismatch

File does not exist, boot failed.

## get_boot_mode_from_bios,  ios_mode : 0, boot_mode : 0

[Sergiu.Daniluk]

Get to loader (ctrl+L) and boot from there the previous image installed (9.2.2). Once you are back to NXOS, verify if the image has the correct MD5 (show file <filename> md5)

Cheers,

Sergiu

[slakos · Accepted solution]

crl+L is correct I can boot from another image

error was because bad compact in Nexus

I get new file from Cisco (n3100-compact.9.3.7.bin)