Hi Folks,
In our data center design, We implemented a new VRF design to segregate the traffic and increase the capacity for specific traffic. So we have configured the 3 sub-interface. Ex Eth 1/49.234 Eth 1/50.234 Eth 1/52.234. We would like to know the counters for the sub-interface as to the below output for the physical interface.
- #sh int eth 1/49 counter
---------------------------------------------------------------------------
Port InOctets InUcastPkts
----------------------------------------------------------------------------------
Eth1/49 1984964821585 15921418838 - ----------------------------------------------------------------------------------
Port InMcastPkts InBcastPkts
----------------------------------------------------------------------------------
Eth1/49 466824 272
When I tried to see on sub inter counter, it shows o values even data is flowing.
- sh int eth 1/52.456 counters
- ----------------------------------------------------------------------------------
Port InOctets InUcastPkts
----------------------------------------------------------------------------------
Eth1/52.456 0 0 - ----------------------------------------------------------------------------------
Port InMcastPkts InBcastPkts
----------------------------------------------------------------------------------
Eth1/52.456 0 0
- sh int eth 1/52.456
Ethernet1/52.456 is up
admin state is up, Dedicated Interface, [parent interface is Ethernet1/52]
Hardware: 1000/10000/25000/40000/50000/100000 Ethernet, address: 3890.a5fa.cea1 (bia 3890.a5fa.ce
de)
Description: eBGP to or1-dccs02-4/31.456 sub-int
Internet Address is 10.50.x.xxx/31
MTU 9216 bytes, BW 100000000 Kbit, DLY 10 usec
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation 802.1Q Virtual LAN, Vlan ID 456, medium is broadcast
Auto-mdix is turned off
EtherType is 0x8100.
Can someone help to understand this and if any resolution or if any config missing.
Thanks!
